Can I use the discharge water for my garden?
The discharge water will contain high levels of mineral salts and you should check with a garden centre before you put this water on your plants. Water from constant bleed systems can be run onto [...]
The discharge water will contain high levels of mineral salts and you should check with a garden centre before you put this water on your plants. Water from constant bleed systems can be run onto [...]
If you have a constant bleed system, you can reduce the flow rate – refer to your Owner’s Manual for information – link to manual download. With water management or Watermiser systems, the [...]
If your cooler has the “no seasonal maintenance” feature / “Watermiser” / drain system fitted, then it will drain all the water out of the unit after a preset period of time (refer to your [...]
If your cooler has the “no seasonal maintenance” feature, “Watermiser” system or drain system fitted, then it will drain all the water out of the unit after a preset period of time (refer to your [...]
Check that your salinity level setting is at ‘high’. Every time you replace the batteries in your remote controller, you need to reset the salinity level setting to high. This is done [...]
This is normal and means your water management or Watermiser system is working correctly. These systems are designed to monitor and control the quality of the water in the tank. So, it only [...]
There are many thousands of evaporative coolers working on bore water in Australia. However, high calcium content bore water will affect the Service life of the filter pads and the unit will also [...]
If you have a Constant Bleed system, you will see a constant flow while the air conditioner’s pump is operating. The amount of water flow will vary depending on the rate set by the installer [...]
Seeley International can not accurately calculate gas, water and or power consumption as any calculation must be based on individual requirements and conditions. The factors that determine the [...]
An evaporative air conditioner uses water and the process of evaporation to produce a cooling effect. Plus, some water is replaced regularly to ensure that the water in the cooler stays clean. [...]